Installation
- Pre-clean the surface of any debris, rust, remove old coatings, if necessary, apply a primer. The surface must be dry.
- Work at a temperature not below +5 ° C, relative humidity less than 85%.
- The adhesive composition mix thoroughly.
- Apply the adhesive composition of the protected surface with a spatula, brush, air or airless spray.
- Cutting basalt fireproof rolled material into pieces of desired size.
- Wrap the surface of the protected structure coated with a layer of wet adhesive foil fireproofing material outward. The edges of the material are mounted with overlap of 50 mm.
- If necessary additionally fastened AUR steel wire as a clamp. At the request of wire and aluminum tape to close the joints.
- Use personal protective equipment. In case of contact with eyes rinse thoroughly with water.
|
Storage and operation conditions
| Storage and transport conditions | temperature - 50 ° C to +60 ° C;
Ograx-K stored and transported in a sealed container;
Ograx-BM Store in a closed, dry rooms with a humidity of 85%, stacked horizontally |
| Storage warranty period | one year from date of manufacture |
Service lifetime
| corresponds to the period of service duct |
|
